How to replace the individual control point (lost or broken) of your Somfy radio roller shutter motor?
Video procedure
Step by step procedure:
Information
This procedure is valid for radio motor:
- Oximo io
- Oximo RTS
- Altus RTS
The following operation must be carried out with individual control point of your roller shutter (remote control or wall-mounted switch).
Double power cut-out
WARNING: This process must be realised on the concerned drive only. The power of the other motors must be completely cut-out. If not all the installation will be reset.
1. Cut-out the power of the concerned drive 2 seconds
2. Turn on the power 8 seconds
3. Cut-out again the power 2 seconds
4. Turn on the power again. The shutter moves for 5 seconds or it makes a brief up and down movement.
Set the new individual control point
Reminder: The power of the other motors must be completely cut-out.
1. Briefly press the prog button on the back of your new control point. The shutter makes a brief up and down movement.
2. Press up or down to check the operation
The new control point is paired with the roller shutter and ready to be used!